Plate & Frame Filter Press

Plate & Frame Filter Press
Plate & Frame Filter Press
Product Code : BE-1103
Brand Name : Biotek
Product Description

Plate & Frame Filter Press

Biotek Engineers is manufacture,exporters & suppliers of : Plate & Frame Filter Press

  1. Pressure filters can apply a large pressure differential across the septum to give economically rapid filtration with viscous liquids or fine solids. The most common types of pressure tilters is filter press.
  2. A Filter press contains a set of plates designed to provide a series of chambers or compartments in which solids may collect. The plates are covered with a filter medium such as canvas cloth. Slurry is admitted to each compartment under pressure; liquor passes through the canvas cloth and out a discharge pipe, leaving a wet cake of solids behind. Plates and frames sit vertically in a metal rack, with cloth covering the face of each plate, and are squeezed tightly together by, screw. Slurry enters at one end of the assembly of plates and frame. It passes through a channel running lengthwise through one corner of assembly.
  3. The set up consists of 7 plates and 6 frames. Frames are covered with filter cloth. Feed is fed b gear pump at the top and filtrate collected at the bottom from each plate by operating the cock. After removing Cake, washing and cleaning can be done by water provided by overhead tank. Inlet & outlet pressures are measured by pressure gauges. Rate of filtrate removals is measure by calibrated tank provided.

 Frame 6 Nos.
 Plates 7 Nos.
 Size 200 mm x 200 mm.
 Material Acrylic (MS/SS on request)
 Screw Jack Arrangement For tightening and removing of frames easily.
 Filter Medium Filter Cloth
 Filtrate Collection Tray Material SS, Suitable size.
 Slurry Feed Tank Material SS, Capacity 40 Ltrs.
 Slurry Tank Agitator SS Impeller with SS Shaft coupled to FHP
 Standard Make Motor and Reduction Gear BI
 Slurry Feed Pump Gear Pump with FHP standard Make motor.
 Piping System GI and PVC
 Filtration Rate Measurement Using measuring tank. Material SS
 Pressure Measurement Bourdon type pressure gauge
 Overhead Water Tank Material SS  , Capacity 25 Ltrs
 Control Panel On / off switch, Mains Indicator & fuse etc

A good quality painted rigid MS Structure is provided to support all the parts.


Contact Details

RFQ Request For Quotation
Get Quotes For Your Buying Requirement. Tell Suppliers What You Need.
I agree to abide by all the Terms and Conditions of
BIOTEK ENGINEERS All Rights Reserved.(Terms of Use)
Developed and Managed by Infocom Network Ltd.